General-purpose filter that allows capturing of computer screen.
After installation of this component you will be able to stream your desktop window or part of it. Capture frame rate can also be configured.

Desktop Region to capture is full screen by default. The default frame rate is 10 frames/sec. The following are configuration registry settings:

HKLM\SOFTWARE\UNREAL\Live\UScreenCapture
DWORD: Left
DWORD: Right
DWORD: Top
DWORD: Bottom
DWORD: FrameRate

Left - is the x-coordinate of the upper left corner of the region to capture in pixels.
Right - is the x-coordinate of the lower right corner of the region to capture in pixels.
Top - is the y-coordinate of the upper left corner of the region to capture in pixels.
Bottom - is the y-coordinate of the lower right corner of the region to capture in pixels.
FrameRate - the valid range is 1 to 30.

Filter reads these values on startup time; in case of invalid or missing values defaults are used. Capturing at high frame rates is very CPU intensive.
Use high bitrate ULiveServer profiles to stream your desktop screen.